Port Service Alarm

This alarm is applicable only to MP-1288.

acPortServiceAlarm

Alarm

acPortServiceAlarm

OID

1.3.6.1.4.1.5003.9.10.1.21.2.0.124

Description

The alarm is sent when an FXS port is out of service due to one of the following:

■

The Serial Peripheral Interface (SPI) connection with the port is lost.

■

The temperature of the port has exceeded the temperature threshold.

■

The port is inactive due to a ground fault.

Alarm Source

Chassis/Module#/FXS Port #

Event Type

equipmentAlarm

Probable Cause

outOfService

Severity

Condition

Text

Corrective Action

Minor

The FXS port is faulty due to the reasons described above.

Note:

■

If the number of faulty FXS ports is greater than four on the same FXS blade, the acModuleOperationAlarm alarm is sent.

■

If there were active call sessions on the device, these calls are disconnected. No new SIP outbound calls will be initiated towards the FXS line.

"FXS Port state was changed to Out of Service"

Note: Detailed reason is provided in the Syslog and Web interface (detailed port status description and tooltip per FXS port).

Service the faulty FXS port.

Clear

The alarm is cleared when:

■

The Serial Peripheral Interface (SPI) connection is restored.

■

The FXS port temperature falls below the threshold.

■

The ground fault is cleared.

■

The acModuleServiceAlarm alarm is sent (i.e. the number of faulty FXS ports on the blade is greater than four).